Pilot Check Valves
Description
Symbol
Cross Section
Cavity Details
72
Technical Features
All external surfaces are zinc plated and cor-
rosion-proof. All valve parts are made of high
strength steel. Poppet is hardened and ground to
guarantee minimal wear and to extend service life.
Pilot piston is hardened and ground, sealed to pre-
vent leakage. Optional bias springs for back-pres-
sure application flexibility. Industry SAE common
cavity.
Cartridge style, normally closed, single pilot
check valve. Cartridge is closed until sufcient
pressure is applied on port 1 to reach the bias
spring setting, lift the poppet and allow free
flow to 2. The valve is normally closed from
2 to 1. When sufcent pressure is applied on
port 3, the pilot piston lifts the poppet from its
seat and allows flow from 2 to 1.
Very limited leakage in the check condition.
SAE10-2
SAE Cartridge - 350 bar
Direct acting check valve
Pilot piston to open
SPC6.S10 Valve Series
Technical Data
Performance Details
Flow (l/min)
Pressure (bar)
73
Specications may change without notice.
Ordering Code
Maximum operating pressure 350 bar
Maximum flow 60 l/min
Maximum Internal Leakage
0,10 cm
3
/ min @ 10 bar
0,10 cm
3
/ min @ 350 bar
External component treatment
Zn/Fe - standard (96h)
Zn/Ni (720h)
Pilot ratio 3:1
O-ring Temperature Range -30° C to 110° C (standard sealing NBR - BUNA-N)
Oil Temperature Range -30° C to 110° C
Fluids Mineral - based or synthetics with lubricating properties
Viscosities 7,4 to 420 cSt
Filtration 20/18/15 ISO 4406 (maximum ltration admitted)
Orientation No restrictions
Installation torque 55-65 Nm
Technical Specications for characterization see page 480
Oil testing condition ISO VG 46 cSt
Seal kit code SK.049
Weight 0,103 kg
Note: The performance
chart illustrates flow han-
dling capacity for signicant
spring bias options. p/Q
curves are recorded at TOil =
40°Cand 46 cSt
